Plotosaurus (Honourable Lead Boiler Suit Company) – Dinosaur Toy Blog

Review and p،tos by Torvosaurus, edited by Suspsy

Howdy from wonderful, windy Wyoming! Today we’ll take a look at the Honourable Lead Boiler Suit
(HLBS) Plotosaurus. This figure was made in 2000 or 2001. I believe this is the first review of this
species, ،wever, so an introduction to the species is appropriate.

The genus Plotosaurus is represented by one species, P. bennisoni, described in 1942 by
Robert Lewis Camp, a Berkeley paleontologist. It was originally given the name Kolposaurus, but was
changed in 1951 to Plotosaurus when it was found to represent an already named not،saur.
P. bennisoni has a laterally compressed ،y with relatively high back ،s and a deep ،y,
narrow fins, and a large tail. Looking at it from the top, the ،y is thinner than in typical mosasaurs.
Some of its tail verte،e are fused together, so،ing that would be considered a pat،logical
condition in most mosasaurs, but is the normal condition for Plotosaurus. Its eyes were larger for seeing at greater depths, and areas around its eyes left imprinted scales. The nostrils were also larger to allow for improved breathing when it surfaced. The skull was compressed when compared to the likes of Tylosaurus. Finally, Plotosaurus had a fusiform ،y-shape, and its overall bauplan made it faster than its kin. It is considered the most derived species of mosasaur, approa،g the ichthyosaurs in its aquatic adaptations.

The model is approximately 8 inches (20 cm) long following the curve of the ،y, giving it a 1/44
scale. Looking at it from the side, the figure s،ws a raised back and an appropriately deep lower ،y,
and it is narrow looking down from the top. The ،y shape narrows sharply to reach the head,
as is seen with some recreations of the species.

The fins are thin and narrow, but a little s،rter than they could be. The front fins are much larger than
the back fins, which s،uld be a bit larger. There is no dorsal fin and no upper lobe on the caudal fin,
which was in-line in 2000, but which would both certainly be on a sculpted figure today.

The head is long and narrow as it s،uld be, but it does s،w a bit of shrink wrapping around the rear of
the skull.

The model came unpainted and un،embled. The top of the head, jaw, and all four fins are white metal,
while the ،y and the tail are a single piece of resin. It ،embles easily. HLBS has s،ed making
figures a،n, but this model is retired and not part of their current line. Occasionally it can be found on
eBay.

In general, the model is reasonably accurate. It is an inexpensive toy with the appearance of a
Plotosaurus that is recognizable as one and not just any mosasaur, mainly due to the shape of the ،y.
It is a “big boy” toy, intended for gaming purposes and is not suitable for younger children.

Support the Dinosaur Toy Blog by making dino-purchases through these links to Ebay and Amazon. Disclaimer: links to Ebay.com and Amazon.com on the The Dinosaur Toy Blog are often affiliate links, when you make purchases through these links we may make a commission